If the camera fails to function as expected, check the list of common prob-lems below before consulting your retaiter or Nikon representative. Refer tothe page numbers in the fight-most column for more information.Display, Settings and Power SupplyProblem Cause/SolutionMonitor is blank • Camera is off. 101611,21256362• Battery is exhausted.• Standby mode for saving power: press theshutter-release button halfway.• When flash lamp blinks red, wait until flashhas charged.• Camera and PC are connected via USBcable.• Camera and TV are connected via A/Vcable.Monitor is hard to read • Adjust monitor brightness. 97• Monitor is dirty. Clean monitor. 110• Monitor has dimmed to save power. Moni- 11tot brightens when controls are used.Camera turns off without • Batteries are low. 16warning • Camera has turned off automatically to 11,save power. 101• Batteries are cold. 110[Format memory]>[Format] Batteries are low. 16,option not available 102Date and time of recording • Pictures recorded before clock has been set 12are not correct will have time stamp of "00.00.000000:00"; voice recording will be dated"01.01.2007 00:00." Set the correct dateand time from [Date] in the setup menu.• Check camera clock regularly against more 94accurate timepieces and reset as required.No indicators displayed in [Hide info] is selected for [Photo info]. Select 97monitor [Show info].[Date imprint] not available Camera clock has not been set. 12, 94Date not appearing on pic- Date does not appear on movies or on pic- 31, 34,tures even when [Date tures taken using ((_111t)),_, _, f:_1,Continu- 36, 38,imprint] is enabled ous, or BSS. 49, 81,822zo117