Nikon COOLPIX P500 User Manual

Also see for CoolPix P500: Brochure Brochure Brochure User manual User manual

3-_u.zorDo-re_I' Cause/Solution _!_!_ [.__'_ProblemBattery temperature is high, Turn off camera, and allowMonitor is turned battery to cool down before resuming use, After the lampoff, and the power blinksforthreeminutes, the camera turns offautomatically, 23on lamp flickers, but you can also press the power switch to turn it offmanually.When functions such as movie recording are used for a longCamera time, or when the camera is used in a location with a high 158temperature rises, am bient temperature, the camera tern perature may rise.Thisis not a malfunction.Electronically Controlled CamerasIn extremely rareinstances, unusual characters may appear on the monitor and thecamera may stop functioning. In most cases,this phenomenon is caused by a strongexternal static charge.Turn the camera off, remove and replace the battery, then turn thecamera on again. Note that disconnecting the power source asdescribed above mayresult in the lossof any data not recorded on the internal memory or memory card at thetime the problem occurred. Data already recorded is not affected. In the event ofcontinued malfunction, contact your retaileror Nikon-authorized service representative.Shooting"2'!w_°°l_"_ol_lem_-':?_?_?_?_?_Ca use/Solution _,_ _Cannot set to Disconnect the HDMI cable or USB cable. 71, 174, 180shooting modeWhen camera is in playback mode, press the [] or 34shutter release button,No picture taken When menus are displayed, press the MENUbutton, 13when shutterrelease button is Battery is exhausted. 28When the scene mode is [] (Night portrait) or NDR in 37, 49, 50pressed, t_ (Backlighting) is Off, raise the flash,When flash indicator blinks, flash is charging. 38Subject is too close to the camera. Try shooting with _ 40, 46, 55(macro close up) in the focus mode, or Scene autoselector or Close-up scene mode.The intended subject is one with which autofocus does 33Camera cannot not perform well.focus, Bet AF assist in the setup menu to Auto, 196Subject not in focus area when shutter release button 32, 95pressed halfway.The focus mode is set to ME(manual focus). 40Turn camera offand then on again, 23224