Nikon DS-2MBW Instruction Manual

Also see for DS-2MBW: Instructions Quick reference

Contents

Nikon DS-2MBW Instruction Manual Manual pdf 49 page image

VI Basic Operations SETUPPreparations Before Photographing- 39 -NOTE: If the message “NG!! Code Error!!” is displayed when you enter the licensecode, check to see that the license code you've entered is correct beforeretrying.The printers to perform the direct printing can be selected from either Mitsubishi CP900D oranyone which supports PictBridge Standard (*).Mitsubishi CP900D selection modeClick the “Mitsubishi CP900D” check box to enter a check mark, then click Save , andturn the power for DS-L1 off. Connect CP900D printer to the USB-H connector on DS-L1and turn the power on again. This will enable printing by CP900D printer.Or, as another method, connect CP900D printer to the USB-H connector on DS-L1 first,then enter a check mark in the “Mitsubishi CP900D” check box, and turn the power forCP900D on. This also will make printing by CP900D printer possible.When this mode is selected, the function to capture the image on the PC by connecting thePC to the USB-D connector on DS-L1 remains enabled. However, even if aPictBridge-supporting printer is connected to the same USB-D connector, printing by thatprinter is not possible.PictBridge-supporting printer selection modeClick the “PictBridge” check box to enter a check mark, then click Save , and turn thepower for DS-L1 off. Connect a PictBridge-supporting printer to the USB-D connector onDS-L1 and turn the power on again. This will enable printing by the PictBridge-supportingprinter.Or, as another method, connect a PictBridge-supporting printer to the USB-D connector onDS-L1 first, then enter a check mark in the “PictBridge” check box, and turn the power forthe PictBridge-supporting printer on. This also makes printing by the PictBridge-supportingprinter possible.When this mode is selected, the function to capture the image on the PC by connecting thePC to the USB-D connector on DS-L1 is disabled. Also, even if a CP900D printer isconnected to the USB-H connector, printing by the printer is not possible.* PictBridge StandardPictBridge is the standard which allows to print the images photographed by a digitalcamera directly, without a PC, and the interconnection between a digital camera and aprinter is supported by manufacturers of respective products.For details, refer to the PictBridge official website: http://www.cipa.jp/pictbridge/1.4.6 Settings for Connecting a MicroscopeTo control the microscope or display the microscope status, you must input your microscopecontrol license code. Otherwise, it will not function.NOTE: For information on purchasing a microscope control license, please contactthe nearest Nikon office or distributor.Follow the procedure given below to set up the microscope control license.1) Display the menu and select the [MIC] tag.2) If the microscope control license has not been acquired yet, a microscope control licenseinput window is displayed.3) Enter your license code in the input window and press Ent . This completes setup. You donot need to restart after setup.NOTE: If a "Code Error!!" message is displayed in 3) above, check your licensecode and reenter.