Nikon SB-600 Instruction Manual

Also see for SB-600: Manual

61● ● ● Settings on the remote flash unitsIn the Advanced Wireless Lighting mode, set the following items on the remoteflash units.Communication channel Select one of the four available channels. Be sure to setthe same channel number for both the master flash unitand remote flash unitsGroup name A maximum of 3 groups (A, B, C)• Set the remote flash units’ flash modes and flash output level compensation values onthe master flash unit.• If wireless repeating flash has been set on the master flash unit, remote flash units suchas the SB-600 will also perform repeating flash operation.• If a photographer uses the same type of wireless remote flash setup near you, yourremote flash units may accidentally fire in sync with that photographer’s master flashunit. To avoid this, use a different channel number.• Refer to your Speedlight instruction manual for information on master flash unit settings.● ● ● Setting a group and channel number on the remote flash units1 Press the a button on the remote flash unit todisplay the blinking channel number, then pressthe i or j button to set the channel number.• Be sure to choose the same channel number as seton the master flash unit.2 Press the a button on the remote flash unit todisplay the blinking group, press the i or j buttonto set the group, then press the a button.• For remote flash units where the flash mode and flashoutput level compensation values are to be setidentically, place these flash units into the same group.v Notes on using the Nikon D70's Commander ModeBe sure to set the channel number of the remote flash unit to 3 and set the groupof the remote flash unit to Group A when performing wireless multiple flash usingthe Nikon D70's built-in flash as a master flash unit (Commander Mode). If you donot follow this procedure, the SB-600 does not fire.Advanced operationsAll manuals and user guides at all-guides.comall-guides.com