Niles A4.6Ci Installation & Operation Manual

Contents

Niles A4.6Ci Installation & Operation Manual Manual pdf 88 page image

88PROGRAM-EDITING STEPSEDIT SOURCE-COMPONENT POWERSteps to edit the IR commands to power IR activated source components.Step 1 - Press and hold the PROGRAM button.The POWER/(MASTER KEY SEQ) LED turns on RED, and the PAGE LED blinks, RED.Step 2 - Press a Master Key where you will edit source component power IR commands.Important Note: Every Master Key that activates a source component with IR must be programmed individually.The PAGE LED turns off, and the ENTER IR LED turns on GREEN.Step 3 - Press the appropriate Power or ON button on the original factory remote.The ENTER IR LED turns on RED to indicate it is ready to receive the OFF command.Step 4 - Press the OFF button on the original factory remote if the component has discrete ON and OFF commands.The ENTER IR LED turns off, and the PAGE LED blinks RED.orPress the PROGRAM button if the component has a single power command for ON and OFF.The ENTER IR LED turns off, and the PAGE LED blinks RED.Step 5 - To test the command(s), press the TEST button. If it does not operate the component as expected,teach and test the command again until it does.Note: Repositioning the remote control when teaching the command can assist in capturing commands accu-rately.Step 6 - If there are other Master Keys to edit, press the appropriate Master Key and then repeat steps 3through 5 until you have edited all the power commands.Step 7 - Press Next to edit Input Selection. The INPUT ASSIGN /(ZONE-SYS. SEQ.) LED turns on RED, andthe PAGE LED blinks RED.orStep 8 - Press PROGRAM to save and exit programming.EDIT INPUT SELECTIONSteps to edit the assigned audio input for the Master Keys.Step 1 - Press and hold the PROGRAM button.Step 2 - Tap the NEXT button once.The INPUT ASSIGN /(ZONE-SYS. SEQ.) LED turns on RED, and the PAGE LED blinks RED.Step 3 - Press the Master Key to edit.The PAGE LED turns off. Either the number 1 INPUT LED turns on RED (by default) or the previously pro-grammed INPUT LED turns on RED.Step 4 - Press the INPUT SELECT button on the front panel to choose the input for that Master Key. Whenthe desired INPUT LED is turned on, press PROGRAM to assign it.The INPUT LED turns off and the PAGE LED blinks RED.