Nilfisk-ALTO ATTIX 30 Operating Instructions Manual

Also see for ATTIX 30 H: Quick start guide Quick start guide Service manual Operating instructions Quick start guide

3ATTIX 30-50 H/MThe vacuum cleaners are suitable to pick updry, nonflammable dust, non flammable liquids, sawdust and•hazadous dusts with OEL values *), carcinogenic dusts, dustscontaining germs.The vacuum cleaners ATTIX 30-XH and ATTIX 50-XH are also ap-proved for asbestos abatement (TRGS 519).The vacuum cleaners are suitable for commercial use, such as e.g.inHotels, Schools, Hospitals, Factories, Shops, Offices, Hire•shopsAny other use is considered as improper use. The manufacturer ac-cepts no liability for any damage resulting for such use. The risk forsuch use is borne solely by the user.Proper use also includes proper operation, servicing and repairs asspecified by the manufacturer. See operating instructions.Transport Before transporting the dirt tank, close all the locks.1.Do not tilt the cleaner if there is liquid in the dirt tank.2.Do not use a crane hook to lift the cleaner.3.Storage Store the appliance in a dry place, protected from frost.1.Maintenance, cleaning andrepairDuring the following work, ensure that dust is not unnecessarilyspread around. Wear a P2 bresthing mask.CAUTION: In the case of asbestos abatement wear additional sin-gle-use clothing.Only carry out maintenance work described in the operating in-structins.Always pull the out the mains plug before cleaning and maintenanceof the vacuum cleaner.During maintenance and cleaning, handle the vacuum cleaner insuch a manner that there is no danger for maintenance staff or otherpersons.In the maintenance areaUse filtered compulsory ventilation1.Wear protective clothing2.Clean the maintenance area so that no harmful substances get3.into the surroundings.Electrical connection It is recommended that the vacuum cleaner should be connected1.via a residual current circuit breaker.Arrange the electrical parts (sockets, plugs and couplings) and2.lay down the extension lead so that the protection class is main-tained.Connectors and couplings of power supply cords and extension3.leads must be watertight.Extension lead As an extension lead, only use the version specified by the man-1.ufacturer or one of a higher quality. See operating instructions.When using an extension lead, check the minimum cross-sec-2.tions of the cable:Cable length Cross section< 16 A < 25 Aup to 20 m 1.5 mm 2 2.5 mm 220 to 50 m 2.5 mm 2 4.0 mm 2*) OEL values = Occupational Exposure Limit