Wheel System, Traction136Service Manual – Floortec 760Drive belt, check/replacementCheck1 Drive the machine on a level floor and ensurethat it cannot move2 Turn the ignition key to “0”3 Remove the hopper by using its transport handleand wheels4 Disengage the front fastener and open thebattery/engine compartment hood.5 Remove the screws (A) and the right side panel(B) from the machine6 Visually inspect the entire length of the drivebelt (C) to make sure it is intact and shows nosigns of cuts, tears or cracks, if necessary replaceit. If necessary, replace the belt.7 Check that the flexible tensioner (D) is workingand that it operates correctly on the drive belt(C) Check that the rotation pulleys of thebelt (C) rotate freely and are free from dirtand foreign materials (ropes clothes, etc. )accidentally rolled up on their rotation shaftsReplacement8 Move the flexible tensioner (D) away from thebelt (C), then release the belt from the pulley(E)9 Remove the belt (C) by disengaging it from thelower pulley and from the drive wheel (F), bygently lifting the wheel itself10 Install the new belt (C) by performing the steps3 to 9 in the reverse order11 Check the drive system control cable (see theprocedure in the relevant paragraph)P200357
