Electrical and Control System57Service Manual – Floortec 760Machine Check/Setting1 Drive the machine on a level floor and ensurethat it cannot move2 Turn the ignition key to “0”3 Remove the hopper by using its transport handleand wheels4 Disengage the front fastener and open thebattery compartment hood5 Disconnect the battery connector6 Check the battery cables for insulation7 Remove the battery charger cable (A) from thehousing; connect it temporarily to the electricalmains and, during the connection, check thenumber and color of the LED flashings (B),then compare them with the indications in thefollowing table, to determine the battery settingof the machineType of battery set onthe machine FlashesEXIDE™ Two flashes of the yellow LEDOPTIMA™ Two flashes of the green and yellowLEDs togetherDISCOVER™ Two flashes of the red and green LEDstogetherGEL/AGM (generic) Two flashes of the green LEDWET (all makes) Two flashes of the red LED8 If it is necessary to install batteries which aredifferent from the machine setting, it is possibleto change the machine settings according to thefollowing procedure9 If equipped, remove the batteries from themachine and also remove the battery caseP200314
