Nilfisk-ALTO SCRUBTEC 770 S 05210F Operator's Manual

-10- FORM NO. 70935A Nilfi sk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795MACHINE CONTROL PANEL 770S, 784S & 795SKey Switch (See Figure #1, Item “A”)The key switch turns “ON” the power to the control panel. “0” is “OFF” and “I” is “ON”.Traverse Speed Switch (See Figure #1, Item “B”)The speed control varies from low to high speed. To increase the speed, turn the knob to the right. To decrease the speed, turn theknob to the left.Brush Up/Down Switch (See Figure #1, Item “C”)The brush switch has two positions: “Up” positions the brushes up; “Down” positions the brushes on the floor. The brush motors startwhen the brushes are down and the traverse switch is depressed.Increase Brush Pressure Switch (See Figure #1, Item D)This switch is used to increase the brush pressure. Increased brush pressure may be required when stripping or cleaning heavilysoiled floors. To increase brush pressure, first lower the brushes by pressing the brush up/down switch (Item “C”) to the downposition. This will lower the brushes to the normal scrub position. To increase brush pressure, press and hold the switch (Item “D”)until the desired brush pressure is reached or the brush deck stops moving downward. To reposition the brush pressure to normalscrub, press the brush up/down switch (Item “C”) to the up position and after the brush deck is completely raised, then return theswitch to the down position for normal scrub.Solution Control Knob (See Figure #1, Item “E”)The solution control knob regulates the flow of cleaning solution to the floor. To increase the flow turn the knob clockwise. Todecrease the flow, turn the knob counter-clockwise.Forward Switch (See Figure #1, Item “F”)The forward switch turns the traverse motor “on” and if the brush motors are in the down position, it also activates the brush motorsand solution control module. Either the right or the left switch can be used.Reverse Switch (See Figure #1, Item “G”)The reverse switch, when used in conjunction with one of the forward switches, causes the machine to reverse direction. The reversespeed is 70% of the forward speed.Charge / Battery Meter (Solo) (See Figure #1, Item “H1”)The charge/battery meter indicates the battery is being charged when the charger is plugged into an AC outlet. It also indicates theamount of charge that is left in the batteries while the machine is in use. When the battery charger gets too low the red light will beginflashing and the brush/pad motors will shut off.Battery Meter / Charge Indicator Light (I-Drive) (See Figure #1, Item “H2”)The battery meter indicates the amount of charge remaining in the batteries while the machine is in use.When the charger is plugged into an AC Outlet, the charge green indicator light will flash on and off. When the batteries become fully charged, thegreen indicator light will remain on until the charger is unplugged.Circuit Breakers (See Figure #1, Item “I”-”M”)The circuit breaker reset buttons are located on the control panel. The breakers are located as follows: Item I & J - Brush Motors(35A); Item K - Traverse Motor (30A); Item L - Vac Motor (25A); Item M - Actuator Motor, Brush Head (5A)If a circuit breaker trips, determine which motor is not operating and turn the key switch “OFF”. Wait five minutes and push the resetbutton back in. Turn the key switch “ON”, and try again. An authorized service person should be contacted if the breaker trips again.Hour Meter (See Figure #1, Item “N”)The hour meter indicates the number of hours the machine has operated. It runs only when the machine is moving forward orreverse.