Nilfisk-ALTO Scrubtec 770 S Operator's Manual

Also see for Scrubtec 770 L: Operator's manual

Nilfisk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795SCRUBTEC 770 / 784 / 795SCRUBTEC 770 / 784 / 795SCRUBTEC 770 / 784 / 795SCRUBTEC 770 / 784 / 795 - 19 -How To Install The Brushes Or Pad DriversTo install the brushes or pad drivers on the machine,follow this procedure:1. Turn the key switch "ON".2. Put the brush switch in the "UP" position.3. Turn the key switch "OFF".4. Go to the front of the machine.5. Unlatch right and left brush housings and removethem. See figure #9.6. Put a brush or pad driver under the brush motor plate.See figure #10.7. Align the lugs on the motor gimbal with the slots in thebrush gimbal.8. Pull the brush up until the gimbal locks.9. Repeat steps 6, 7, and 8 to install the second brushor pad driver.How To Remove The Brushes Or Pad DriversTo remove the brushes or pad drivers from the machine,follow this procedure:1. Turn the key switch "ON".2. Put the brush switch in the "UP" position.3. Turn the key switch "OFF".4. Go to the front of the machine.5. Push down on two sides of the brush or pad driver untilthe gimbals release.HOW TO PREPARE THE MACHINEFOR OPERATIONFigure #9Figure #10