INSTRUCTIONS FOR USE30 9096910000(1)2006-09TROUBLESHOOTINGFor further information, refer to the Service Manual, available at any Nilfisk-Advance Service Center.SCRAPPINGHave the machine scrapped by a qualified scrapper.Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according tothe Law in force:– Batteries– Brushes/pads– Plastic hoses and components– Electrical and electronic components (*)(*): Refer to the nearest Nilfisk-Advance Center especially when scrapping electrical and electronic components.Trouble Possible Cause RemedyThe motors do not work; no warning light turnson.The battery connector (12) is disconnected. Connect.The batteries are completely discharged. Charge the batteries.The machine does not moveThe machine has been turned on by usingthe ignition key (80) and by keeping thepaddle (83) pressed.Turn the ignition key (80) to “0” position, thentry to start the machine without pressing thepaddle (83).The brushes do not work, the red warning light(81c) is on. The batteries are discharged. Charge the batteries.Insufficient recovery water vacuuming.The recovery water tank (21) is full. Empty the tank.The hose (15) is disconnected from thesqueegee. Connect.The vacuum grid (36) is clogged or the float isstuck closed. Clean the grid or check the float.The squeegee (25) is dirty or the squeegeeblades are worn or damaged. Clean and check the squeegee.The tank cover is not correctly closed, or thegasket (31) is damaged, or the compensationhole (33) is clogged.Close the cover correctly, or replace thegasket or clean the compensation hole.Insufficient solution flow to the brushes.The solution filter (54) or the clean water filter(51) is dirty. Clean the filter.The tank (21) is dirty (the drain hole isclogged). Clean.Marks caused by the squeegee.There are debris under the squeegee blades. Remove the debris.The squeegee blades are worn, chipped ortorn. Replace the blades.The squeegee has not been balanced withthe handwheel (27). Balance.NOTEThe machine cannot operate without the battery charger.In case of battery charger malfunction, contact an authorized Service Center.