Nilfisk-Advance BA 551 Operator's Manual

Also see for ecoflex BA 551: Service manual User manual User manual Instructions for use

ENGLISH USER MANUAL24 909 6752 000(3)2010-03 A BA 551 - BA 551D - BA 551CD - BA 611DSQUEEGEE BLADE CHECK AND REPLACEMENTClean the steel squeegee (Fig. 6) or the aluminium squeegee (Fig. 7), according to the procedure shown in the previous1.paragraph.Check that the edges (E, Fig. 6 or 7) of the front blade (C) and the edges (F) of the rear blade (D) lay down on the same level,2.along their length; otherwise adjust their height according to the following procedure:Release the tie rod (G, Fig. 6 or 7) and loosen the wing nuts (H, Fig. 6), or disengage the fasteners (M, Fig. 7) and adjust•the rear blade (D, Fig. 6 or 7), then tighten the wing nuts, or engage the fasteners, and then engage the tie rod.Loosen the handwheels (I) and adjust the front blade (C, Fig. 6 or 7); then tighten the handwheels.•Check the front blade (C, Fig. 6 or 7) and rear blade (D) for integrity, cuts and tears; if necessary replace them according to the3.following procedure. Check the front corner (J) of the rear blade for wear; if necessary, overturn the blade to replace the worncorner with an integral one. If the other corners are worn too, replace the blade according to the following procedure:Release the tie rod (G), remove the wing nuts (H) or disengage the fasteners (M), remove the retaining strip (K), then•replace/overturn the rear blade (D).Install the blade in the reverse order of removal.Unscrew the handwheels (I) and remove the retaining strip (L), then replace the front blade (C).•Install the blade in the reverse order of removal.After the blade replacement (or overturning), adjust the height as shown in the previous step.Connect the vacuum hose (15) to the squeegee.4.Install the squeegee (25) and screw down the handwheels (26).5.If necessary, adjust the squeegee balance adjusting handwheel (27).6.Figure 6S311318IBAMGADCIMKFJEDCLIFigure 7S311318