Nilfisk-Advance BR 1100S Service Manual

Also see for 56413006: Instructions for use Instructions for use - original instructions

Contents

Nilfisk-Advance BR 1100S Service Manual Manual pdf 51 page image

FORM NO. 56043122 - BR 1100S, 1300S - 49REAR WHEEL SYSTEM - 7FIGURE 7.1REAR WHEEL & BRAKE CALIPER REMOVALWARNING!Install wood blocking in front and behind the front drive wheel to prevent the machine from rolling.Removal1 Grip the brake lever Return Spring (A) and pull back to remove it from the retainer Bolt (B) mounted to the chassis.2 For the left side wheel only: unclip the brake cable Clevis Pin (C) at the arm and remove it from its brake arm mounting hole.3 For the right side wheel only: remove the Cotter Pin (D) from the Brake Linkage Rod (E) and separate it from the brake arm mounting hole.4 Loosen the center hex Screw (F) that fastens the Rear Wheel (G) to the axle.5 Position a suitable jack underneath the wheel axle and jack up the machine so that the wheel is off the floor approximately 1 inch.WARNING!Place wood blocking under the rear axle as the machine is only being supported by the jack. This is to prevent any accidents or machine damagewhen the wheel is off.6 Carefully pull the complete wheel brake assembly off the axle. If replacing the wheel remove the (4) Nuts (H) and Screws (J) that retains the brake rotor to thewheel hub.Re-Install7 If replacing wheel reattach the salvaged brake rotor to the new wheel hub then place the brake caliper onto the rotor and align caliper slots with the chassisand slide the assembly onto the axle. Special Service Note: Apply a small amount of Loctite 242 (blue) thread sealant to the wheel hub Screw (F) to preventloosening of the screw. Also use an 11/16 inch wrench to install or remove the retainer wheel screw.