Nilfisk-Advance SC351 Use And Maintenance

Also see for SC351: Service manual User manual Instructions for use Operator Poster Use and maintenance

Nilfisk-Advance SC351 Use And Maintenance Manual pdf 1 page image

Nilfisk A/SKornmarksvej 1DK-2605 BrøndbyDenmarkTel.: +45 43 23 40 50Fax: +45 43 43 77 00mail.com@nilfisk.comwww.nilfisk.comIf the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this thisprocedure may cause damage to the batteries. Charging the batteries after every use is recommended.PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASISUse and Maintenance- SC351ATTENTION! Do not use the machine before you have read and understood the User Manual3. Always follow the dilution instruc-tions on the label of the chemicalproduct used to prepare thesolution. The solution temperaturemust not exceed 40°C and be nonefoaming2. Fill the tank with a solution suitablefor the work to be performed.4. Place the brushes or the pad-holdersunder the deck. Use the appropriatebrushes to clean the floor.5. Turn the knob on one of theindicated programs1. Disconnect the battery charger cablefrom the electrical main.18. Park the machine with the recoverytank cover open.16. Clean the machine using a dampcloth and where needed use a neu-tral cleaning product.17. Charge the batteries: Connect thebattery charger cable from the elec-trical main.13. Remove the brushes and cleanthem.11. Wash with clean water the recoverytank.12. Wash with clean water the vacuumgrid.14. Take the squeegee off and removedebris.15. Check and clean the squeegeeblades.8. Press the enabling push-button to-gether with the brush levers for start-ing floor cleaning. If solution appliedflows outside the brush housing dur-ing use, reduce the flow of solution.6. Press the enabling push-button to-gether with the brush levers to en-gage the brush/pad-holder and thenrelease it.7 . Press the solution flow controlswitches as necessary, dependingon the type of cleaning to beperformed.9. Turn the knob to “0” position toswitch off the machine.10. At the end of the work. Empty therecovery. Then empty the solutiontank.

/ 2

Related manuals for Nilfisk-Advance SC351