Nilfisk Ltd.Nilfisk House · Bowerbank Way ·Gilwilly Industrial Estate · Penrith ·Cumbria · CA11 9BQTel.: 01768 868995 (UK) · 01 2943838 (IE)Email: sales.uk@nilfisk.com (UK & IE)www.nilfisk.co.uk · www.nilfisk.ieIf the machine has been used until the red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this thisprocedure may cause damage to the batteries. Charging the batteries after every use is recommended.Use & maintenance- SC53017. Charge the batteries: Connect thebattery charger cable to the mainselectricity supply..16. Clean the machine using a dampcloth and where needed use aneutral cleaning product.18. Park the machine with the recoverytank cover open.15. Clean the filter by removing thetransparent cover and the gasket.14. Check and clean the squeegeeblades.10. Once you have finished cleaningempty the recovery tank with the hose.Then empty the solution tank with thetrasparent hose.11. Wash with clean water the recoverytank and the vacuum grid.12. Press the click-off button and waitfor the brush/pad holder to fallon the floor. Remove to clean orchange brush.13. Take the squeegee off and removedebris.5. Place the brush or the pad-holderunder the deck. Use the appropriatebrush to clean the floor.6. Lower the brush deck with the pedal. 8. Adjust (if needed) the solution flowlevel according to the cleaningperformance and application.7. Turn on the key, then slightly press thehandle switch to engage the brush.2. Fill the tank with a clean water. Theclean water temperature must notexceed 40 °C.1. Disconnect the battery charger cablefrom the mains electricity supply.3. If the squeegee is not connected tothe machine: install and fasten it withthe handwheels, then connect to thesuction hose.4. If the squeegee is in upper position,lower it with the lever.ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual