Nilfisk A/SKornmarksvej 1DK-2605 BrøndbyDenmarkTel.: +45 43 23 40 50Fax: +45 43 43 77 00mail.com@nilfisk.comwww.nilfisk.comIf the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this thisprocedure may cause damage to the batteries. Charging the batteries after every use is recommended.PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASISUse & maintenance- SC45017. Charge the batteries: Connect thebattery charger cable from theelectrical main16. Clean the machine using a dampcloth and where needed use aneutral cleaning product18. Park the machine with the recoverytank cover open15. Clean the filter by: Remove thetransparent cover and the gasket14. Check and clean the squeegeeblades10. At the end of the work. Emptythe recovery tank with the hose. Thenempty the solution tank with thetrasparent hose11. Wash with clean water the recoverytank and the vacuum grid12. Remove the brush/pad and cleanthem13. Take the squeegee off and removedebris.5. Place the brush or the pad-holderunder the deck. Use the appropriatebrush to clean the floor.9. Press the handle switch to engagethe brush and run the machine6. Adjust (if needed) the brush deckto have the correct machinedirectionality8. Switch on the brush and vac motorsto activate the machine7. Press the eco solution flow controlvalve2. Fill the tank with a clean water. Theclean water temperature must notexceed 40 °C.1b. Disconnect the battery chargercable from the electrical main.3. If the squeegee is not connected tothe machine: install and fasten it withthe handwheels, then connect to thesuction hose1a. Switch off charger by unplugcharger cable from red battery plug.Reconnect the red battery plug tothe machine..4. If the squeegee is in upper position,lower it with the leverATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual