7 - FORM NO. 56041529 - SD 130INTRODUCTIONThis manual will help you get the most from your SD 130. Read it thoroughlybefore operating the machine.This product is intended for commercial use; polishing, spray buffing, scrubbing,stripping and rotary carpet shampooing.PARTS AND SERVICERepairs, when required, should be performed by your Authorized Nilfisk-Ad-vance Service Center, who employs factory trained service personnel, andmaintains an inventory of Nilfisk-Advance original replacement parts and acces-sories.Call the NILFISK-ADVANCE DEALER named below for repair parts or service.Please specify the Model and Serial Number when discussing your machine.(Dealer, affix service sticker here.)NAME PLATEThe Model Number and Serial Number of your machine are shown on theNameplate on the bottom of the machine. This information is needed whenordering repair parts for the machine. Use the space below to note the ModelNumber and Serial Number of your machine for future reference.MODEL NUMBERSERIAL NUMBERUNCRATE THE MACHINEWhen the machine is delivered, carefully inspect the shipping carton and themachine for damage. If damage is evident, save the shipping carton so that it canbe inspected. Contact the Nilfisk-Advance Customer Service Departmentimmediately to file a freight damage claim.(A)-KNOW YOUR MACHINE1 Operator Hand Grips2 Switch Lever Safety Lock Button3 Switch Levers - Squeeze - ON / Release - OFF4 Handle Adjustment Lever5 Power Cord6 Operator Handle7 Cord HookWARNING!This machine contains moving parts. To reduce the risk of injury,always unplug the power cord before servicing.(B)-INSTALLING THE BRUSH OR PADHOLDERAlign the Lugs (A) with the corresponding Slots (B) in the brush or pad holder andturn the brush or pad holder counterclockwise to lock it in place. To remove brush/pad holder, give it a quick, hard turn clockwise.CAUTION!Using the wrong brush or pad on this machine can damage thefloor or overload the motor.OPERATION1 Unwrap the Power Cord (5) and plug it into a properly grounded outlet.2 Loosen the Handle Adjustment Lever (4). Move the Operator Handledownward until your arms are almost straight. Then step down on top ofthe Lever (4) to lock it.3 Lift the Handle until the brush (or pad) is flat against the floor.WARNING!Be prepared to control the machine as soon as the motor starts.Just a slight up or down movement of the Handle will make themachine move from side to side. Raise the Handle to go right.Lower the Handle to go left.CAUTION!Immediately start moving the machine back and forth. Keep themachine moving while the motor is running to avoid damage to thefloor or carpet.4 Hold one of the Operator Hand Grips (1) firmly, push the Safety LockButton (2) and then compress the Switch Levers (3) to start the motor.NOTE: When the dual controlled switch levers are released, the machineshuts off immediately.NOTE: When spray buffing, check the pad every 15 minutes for dirt andwax build-up. If the pad is dirty, turn it over to expose the clean side orinstall a clean pad.AFTER USE1 Unplug the Power Cord, wrap it around the Operator Hand Grips (1) andthe Cord Hook (7).2 Remove the pad holder or brush from the machine. Clean the pad orbrush and hang it up to dry. Allow buffing pads to dry completely beforeusing again.Store brushes and pad holders separate from the machine. Never storethe machine with the pad holder or brush on the machine.3 Wipe the entire machine with a clean, damp cloth. Wipe the underside ofthe brush housing after wet use.4 Inspect the entire machine and all accessories for damage. Perform anyrequired maintenance or repairs before storage.5 Store the machine in a clean, dry place with the Handle locked in theupright position.