Nilfisk-Advance SWEEPER SW 700S P User Manual

Also see for SW 700S P: Technical specification

Contents

Nilfisk-Advance SWEEPER SW 700S P User Manual Manual pdf 62 page image

ENGLISH USER MANUAL20 146 0676 000(5)2007-06 A SW 700S PTROUBLESHOOTINGTrouble Possible cause RemedyThe engine does not start when pulling thehandle.The ignition key is not turned to “I”. Turn the ignition key to "I".The engine oil level is low. Add engine oil. (1)The fuel tap is closed. Open the fuel tap.The fuel tank is empty. Refuel.The hood is not properly closed. Close the hood properly.The fuel does not reach the carburettor. Check if the fuel reaches the carburettor. (1)The spark plug does not produce a spark. Clean/replace the spark plug. (1)The engine stops during operation. The engine oil level is low. Add engine oil. (1)The fuel tank is empty. Refuel.The side broom does not operate.The side broom is not lowered. Lower the side broom.The side broom belt or belt tensioner is notefficient.Contact an authorised Nilfisk-AdvanceService Center.When pulling the drive lever, the machine doesnot move, or it moves slowly.The pedal brake (optional) is engaged. Release the pedal brake (optional).The driving belt tensioner is not operating. Contact an authorised Nilfisk-AdvanceService Center.The driving belt is not efficient. Contact an authorised Nilfisk-AdvanceService Center.(1) For the relevant procedure, see the Petrol Engine Manual.For further information, refer to the Service Manual, available at any Nilfisk-Advance Service Center.SCRAPPINGHave the machine scrapped by a qualified scrapper.Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to theLaw in force:Polyester dust filterMain and side broomsEngine oilPlastic hoses and componentsElectrical and electronic components (*)(*) Refer to the nearest Nilfisk-Advance Center especially when scrapping electrical and electronic components.–––––