Check the Power ON/OFF status after assembly.For your safety, your miniPRO is not activated at this time and will beep occasionally after Power ON.Until activated, the miniPRO maintains a very low riding speed and steering sensitivity, and should not be ridden. Install theNinebot by Segway App on your mobile device (with Bluetooth 4.0 or above), connect to the miniPRO with Bluetooth, and followthe App instructions to activate your miniPRO and follow the training procedures.5 Assembling Your miniPRO1 2 3Open the tool-free release as shown. Insert the steering bar into themainframe steering socket.Close the tool-freerelease to secure.Rotate height adjustmentknob counter-clockwise.Lift the knee pads to desired height.Rotate height adjustment knobclockwise to tighten.Lift the guide bar to help steerthe miniPRO without a riderwhen powered on. Do not useto lift or carry the miniPRO.Adjust the knee pad heightInstall the steering bar04 05When Bluetooth is enabled but not connected to a smart phone, this icon will blink.When the Ninebot by Segway App is connected to the miniPRO, this icon will glow steadily.BluetoothEnable and adjust Speed Limit Mode via the App. When the icon is illuminated the miniPROis limited to 7 km/h. This speed limit can be adjusted in the App. As you approach the speedlimit, the miniPRO tilts back.SpeedLimitLockPowerButtonTurn ON/OFF. The miniPRO will automatically power OFF when idle for 10 minutes,or when laid down (horizontal) for over 30 seconds.PowerLevelEnable Lock Mode via the App. The miniPRO will vibrate, flash its lights, and sound an alarmif anyone moves it. The App will also alarm. The miniPRO will not balance in Lock Mode.Indicates the remaining battery life. When the battery is nearly empty this icon blinks and theminiPRO beeps, indicating that you need to charge your miniPRO. When less than 30%, yourminiPRO will gradually reduce the max speed limit. Use the App to read the remaining powerand estimated remaining range.Power ButtonLockBluetoothSpeed LimitPower Level4 Dashboard Icons