Ninja BL660W Owner's Manual

Also see for BL660W: Owner's guide Owner's manual

Contents

10ninjakitchen.comAssembly & Use of the Nutri Ninja® CupFor best results, use short “PULSES”... Practice makes perfect!!Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 6ASSEMBLY USE REMOVALWARNING: Handle the Nutri Ninja Blade Assembly with care, as the blades are sharp.WARNING: Remove utensils prior to processing. Failure to remove may cause the Nutri Ninja cup to bedamaged or to shatter, which may cause personal injury.WARNING: Never leave the appliance unattended while in use.CAUTION: Do not blend hot liquids, doing so may cause excessive pressure buildup, resulting in risk of theuser being burned.CAUTION: Remove the Nutri Ninja Blade Assembly from the Nutri Ninja cup upon completion of blending. Donot store ingredients before or after blending them in the cup with the blade assembly attached. Some foodsmay contain active ingredients or release gases that will expand if left in a sealed container, resulting inexcessive pressure buildup that can pose a risk of injury. For ingredient storage in the cup, use only To-GoLid to cover.IMPORTANT: Make sure that the motor base is plugged in for use.Fig. 51 Review warning and caution statements above beforeproceeding to number 2.2 Place the motor base on a clean, dry, level surface suchas a counter or table top.3 Add ingredients to the Nutri Ninja cup.NOTE: Do not overfill! To avoid spilling, do not addingredients past the “Max” fill line.4 Place the Nutri Ninja Blade Assembly onto the cup andscrew it tightly until you have a good seal. (Fig. 1)5 Turn the Nutri Ninja cup upside down and place itonto the motor base, aligning the tabs on the cup withthe motor base. Turn the Nutri Ninja cup clockwise tolock into place. You will hear a click when the lock isengaged. (Fig. 2)6 Press down on the Single Serve button in shortintervals to activate. (Fig. 3)7 When you have reached your desired consistency, stopthe appliance by removing your hand from the SingleServe button.8 To remove the Nutri Ninja cup, ensure that the motorhas stopped running. Then turn it counter-clockwise(Fig. 4) and pull straight up to remove. (Fig. 5)9 Turn the cup upright and remove the Nutri Ninja BladeAssembly by twisting the blade assembly counter-clockwise. (Fig. 6)10 Do not store blended contents with the Nutri NinjaBlade Assembly attached.11 Place the To-Go lid onto the Nutri Ninja cup, twist toseal and enjoy!12 For storage, only use the To-Go lid to cover.13 Be sure to store the Nutri Ninja Blade Assemblyattached to an empty cup when not in use.14 Make sure that the motor base is unplugged when notin use.