8NZ: 0800 002 999Fig. 3bFig. 2Fig. 1Assembly and Use for the 2.1L PitcherIMPORTANT: Make sure that the motor base isplugged in for use.1 Place the motor base on a clean, dry, level surface suchas a counter or table top.2 Align and lower the Pitcher onto the motor base. (Fig. 1)Handle should be aligned slightly to the right of the“LOCK” symbol on the motor base.3 Rotate the pitcher clockwise as far as it will go to lockin place. (Fig. 2)4 The pitcher can be placed on the motor base two ways;the handle can be on the front right corner or the frontleft corner. (Fig. 3a, Fig. 3b)5 Holding the 6-Blade Assembly by the top of the shaft,place it onto the drive gear inside the pitcher. Ensurethat the attachment is seated properly and is standingupright. (Fig. 4)NOTE: The blade will fit loosely on the drive gear.6 Add the ingredients to the pitcher, making sure not tooverfill.NOTE: Do not exceed the highest measured markingline on the side of the pitcher.NOTE: If you need to add additional ingredients whilethe appliance is blending, open the pour spout cap andpour the ingredients in through the opening.7 Plug the power cord into the electrical outlet and pressthe power button ( ).NOTE: As a safety feature, the powerbutton ( ) will flash and the motor will not workif the pitcher and lid are not installed correctly.When the pitcher and lid are installed properly,the power button ( ) will be solid, indicating thatthe appliance is ready for use.8 Holding the lid by the handle in the upright position, placeit on top of the pitcher aligning the arrow ( ) located onthe lid with the arrow ( ) located on the pitcher’s handle.(Fig. 5) Press the handle down until you hear a click.Fig. 4Fig. 5AssemblyFig. 3a