Ninka Qanto Instructions For Use Manual
Also see for Qanto: Instructions for useInstructions for use
                        | |
Contents
| 
16ENQanto_Id_A5_0000.50.65060_23032018-EN6.8 InitialisationBefore and during initialisation, check and make sure that the safety switch-es are contacted.The lifting system is initialised by pressing and holding the button.It must be kept pressed until the drive reaches the lower end position. Assoon as the drive stops in the lower end position, the button must be re-leased for 2-3 seconds.Then the button must be kept pressed for an additional 6-8 sec-onds. After that, the initialisation procedure is completed. During initialisation,the trays are lowered by 5 mm and then raised again.Please do NOT release the button during initialisation.If the button is released before the procedure has been concluded, theinitialisation procedure is interrupted and must be restarted. If an initialisationprocedure is interrupted, an upward movement of the trays is not possible.During initialisation, the safety switches must be contacted. If the initialisa-tion procedure cannot be concluded, the upper tray must be removed andthe two safety switches must be pressed manually during the initialisationprocedure. |
Related manuals for Ninka Qanto
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine