NiteRider Flight User Manual
                | |
10To access the LED lighting modes, first turn on the HID lampper the HID lighting instructions. Then press and hold thepower button for approximately six seconds until the HID bulbgoes out and the LEDs come on in steady mode.To cycle the LEDs through daylight flash, SOS, and steadymodes, consecutively press and release the power button. Toturn the LEDs off and the HID bulb back on, press and holdthe power button for approximately six seconds. Or to turn thelamp off, press and hold the power button for approximatelythree seconds.Note: Should the HID lamp become damaged or fail whileriding, the LEDs will light automatically as a safety feature.Fuel Gauge and Automatic Shut OffThe fuel (battery) gauge is a series of five indicator LEDswithin the headlamp power button, four of which are greenand one of which is red. When all green LEDs are brightly lit,the battery is fully charged. As the battery discharges one-fourth increments of its capacity, the green LEDs will go outone by one. When the battery is near depletion, the red LEDwill illuminate. At this time, the headlamp should be turned offand the battery recharged.If use continues, the HID headlamp will automatically shut offto avoid overly discharging the battery. As a safety feature,the LED auxiliary lights will automatically turn on when theHID lamp shuts off. The LED lights consume minimal powerand will run for several hours.O P E R A T I O NC O N T I N U E D |
Related manuals for NiteRider Flight
manualsdatabase
Your AI-powered manual search engine