Nitto Kohki DLV04C10L-AY Instruction Manual

Contents

Nitto Kohki DLV04C10L-AY Instruction Manual Manual pdf 24 page image

22EN7 Basic SettingsOperation modeThe tool can be set to handle various screw tightening.You can enter each mode from the screw fastening mode.For details on operation and the operation of each function, see the reference page.Mode Operation Operation to return to screw fastening mode ReferenceSetting mode Press and hold the [SETTING] dial Press and hold the [SETTING] dial p. 22Screw count reset In count down state, press and holdthe [WORK RESET] button Return automatically p. 44Operations channelreturnIn count set value state, press andhold the [WORK RESET] button Return automatically p. 44Operations channelswitching(during INPUT setting)Channel A/B input signal ON Return automatically p. 45External input signalstartupForward rotation startup/Reverserotation startup input signal ON Return automatically p. 45Count return mode(during ON2 setting)With the changeover switch in thereverse rotation side state, press the[SETTING] dialAfter reverse rotation: ReturnautomaticallyOr changeover switch operationp. 33Controller buttonoperation lock/release Key lock input signal ON/OFF Return automatically p. 46Manual mode Press and hold the [MANUAL] button Press and hold the [MANUAL] button p. 21Setting mode operationCAUTIONzz Always record the set values. Utilize “Setting memo” (p. 63).If the tool fails, all settings may be initialized. Also, settings may be initialized at the time of repair in order tocheck operation.Please note that there is no function to output the set values to an outside device.1 In screw fastening mode, press and hold the [SETTING] dialThe mode enters setting mode.2 Rotate the [SETTING] dial, and display the item tochangeThe setting item is displayed in the 1st line on the LCD, andNo. flashes.If [WORK RESET] button is pressed and held while No. isflashing, it returns to the operations mode without changingthe setting.Flashes3 Press the [SETTING] dialThe set values of the displayed setting item can now be changed.4 Rotate the [SETTING] dial, and change the valueThe value selected flashes.If [WORK RESET] button is pressed while the value isflashing, it returns to Step 2 without changing the setting.Flashes