NoiseMeters NNR-P-A1 User Manual
                     | |
Contents
| 
Getting StartedIt is recommended that you connect the sound level meter to the NoiseTools software andcheck that the instrument is configured as required before deployment.See page 14 for details of the configuration options that are specific to the Noise NuisanceRecorder.Connecting the cablesThe NNR is shipped with the cables connected so that it can be setup quickly and easily.The power supply and microphone cable can be disconnected from the case. This allowsthe cables to be replaced if they become damaged.To remove the cables from the case, gently pull the rubber surround upwards and awayfrom the case. The cable and rubber surround will slide out of the slot. To replace thecable, gently guide the rubber surround and cable back into the slot in the case.Connecting the microphone & preamplifierThe microphone and preamplifier are stored inside the case next to the sound level meter.Carefully remove the microphone & preamplifier from the case and connect to themicrophone extension cable.Take care when connecting the cable to the preamplifier. The socket and plug will onlyconnect in one orientation and care should be taken to ensure that the plug and socket arecorrectly aligned.Gently insert the plug into the socket ensuring that the pins are correctly aligned. Once theplug has been pushed fully into the socket, tighten the locking ring by hand.Take care not to over tighten the locking ring.Mounting the microphoneThe microphone and preamplifier are mounted onto atripod which can be positioned away from the maincase in the most appropriate location.To mount the microphone and preamplifier to the tripod,carefully push them through the holes on the tripodmount.The case has a cut out that allows the preamplifier andthe tripod mount to remain coupled when they are not being used.NNR-P-Ax User Manual v1.0.0 5 |
Related manuals for NoiseMeters NNR-P-A1
manualsdatabase
Your AI-powered manual search engine