S e t t i n g s53FCC DRAFTTouch tones are sent during an active call. You can send them manually fromyour phone keypad, or send them automatically by saving them in your phone.Set typeIn the standby mode, select Menu > Settings > Phone settings > Touch tones >Manual touch tones and on of the following options:Continuous—The tone sounds for as long as you press and hold a key.Fixed—Used to send tones of the duration you specify in the Touch tone lengthoption.Off—Used to turn off tones. No tones are sent when you press a key.Set lengthYou can also specify touch tone length when using the Fixed option.In the standby mode, select Menu > Settings > Phone settings > Touch tones >Touch tone length > Short (0.1 seconds) or Long (0.5 seconds).Welcome noteYou can write a welcome note that briefly appears whenever you switch yourphone on, if provided by your service provider.Predictive text input is not available for entering welcome note text.1. In the standby mode, select Menu > Settings > Phone settings > Welcomenote.2. Enter a note (up to 44 characters). Press * to display and select from availablespecial characters.3. When you are finished, select Options > Save.Select Delete if you want to delete the previous text and begin creating anotherwelcome note.BannerBanner is a network service. See "Network Services," page 7 for moreinformation.If your wireless service provider supports this feature, then you can choosewhether the display shows the operator logo when the phone is in the idle state.In the standby mode, select Menu > Settings > Phone settings > Banner >Default or Customize.