Nokia 5070 Owner's Manual

Also see for 5070 - Cell Phone 4.3 MB: Specification sheet User guide User guide

Contents

Nokia 5070 Owner's Manual Manual pdf 104 page image

104Copyright © 2006 Nokia. All rights reserved.facilities, vehicles using liquefied petroleum gas (such as propane or butane), and areas where the air contains chemicals orparticles such as grain, dust, or metal powders.■ Emergency callsImportant: Wireless phones, including this device, operate using radio signals, wireless networks, landlinenetworks, and user-programmed functions. Because of this, connections in all conditions cannot be guaranteed.You should never rely solely on any wireless device for essential communications like medical emergencies.To make an emergency call:1. If the device is not on, switch it on. Check for adequate signal strength.Some networks may require that a valid SIM card is properly inserted in the device.2. Press the end key as many times as needed to clear the display and ready the device for calls.3. Enter the official emergency number for your present location. Emergency numbers vary by location.4. Press the call key.If certain features are in use, you may first need to turn those features off before you can make an emergency call. Consultthis guide or your service provider for more information.When making an emergency call, give all the necessary information as accurately as possible. Your wireless device may bethe only means of communication at the scene of an accident. Do not end the call until given permission to do so.■ Certification information (SAR)This mobile device meets guidelines for exposure to radio wavesYour mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio wavesrecommended by international guidelines. These guidelines were developed by the independent scientific organizationICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health.The exposure guidelines for mobile devices employ a unit of measurement known as the Specific Absorption Rate or SAR. TheSAR limit stated in the ICNIRP guidelines is 2.0 watts/kilogram (W/kg) averaged over 10 grams of tissue. Tests for SAR areconducted using standard operating positions with the device transmitting at its highest certified power level in all testedfrequency bands. The actual SAR level of an operating device can be below the maximum value because the device isdesigned to use only the power required to reach the network. That amount changes depending on a number of factors such