● WEP key in use — Select the wired equivalent privacy (WEP) key number. Youcan create up to four WEP keys. The same settings must be entered on the WLANaccess point device.● Authentication type — Select Open or Shared for the authentication typebetween your device and the WLAN access point device.● WEP key settings — Enter WEP encryption (length of the key), WEP keyformat (ASCII or Hexadecimal), and WEP key (the WEP key data in the selectedformat).Security settings for 802.1x and WPA/WPA2● WPA/WPA2 — Select the means of authentication: EAP to use an extensibleauthentication protocol (EAP) plug-in, or Pre-shared key to use a password.Complete the appropriate settings:● EAP plug-in settings — Enter the settings according to the instructions fromyour service provider.● Pre-shared key — Enter a password. The same password must be enteredon the WLAN access point device.● WPA2 only mode — Only WPA2 enabled devices are allowed to establish aconnection in this mode.Advanced WLAN settingsSelect Options > Advanced settings and from the following:● IPv4 settings — Enter the IP address of your device, the subnet IP address, thedefault gateway, and the IP addresses of the primary and secondary DNS servers.Contact your internet service provider for these addresses.● IPv6 settings — Define the type of DNS address.● Ad-hoc channel (only for Ad-hoc) — To enter a channel number (1-11)manually, select User defined.● Proxy server address — Enter the address for the proxy server.● Proxy port number — Enter the proxy port number.Active data connectionsSelect Menu > Settings and Connectivity > Connection mgr..In the active data connections view, you can see the open data connections:© 2009 Nokia. All rights reserved. 99
