111. Remove the back cover of the phone.2. Insert the card into the microSD card slot with thegold-colored contact area on the card facing down,and press it until it locks into place.3. Replace the back cover of the phone.A memory card is not included in the sales pack.■ Remove the microSD cardImportant: Do not remove the memory card in the middle of an operation when thecard is being accessed. Removing the card in the middle of an operation may damagethe memory card as well as the device, and data stored on the card may be corrupted.You can remove or replace the microSD card during phone operation without switching thephone off.1. Make sure that no application is currently accessing the micro SD memory card.2. Remove the back cover of the phone.3. Press the microSD card slightly in to release the lock and remove it.■ Charge the batteryCheck the model number of any charger before use with this device. This device is intendedfor use when supplied with power from the AC-5 charger.Warning: Use only batteries, chargers, and enhancements approved by Nokia foruse with this particular model. The use of any other types may invalidate anyapproval or warranty, and may be dangerous.For availability of approved enhancements, please check with your dealer. When youdisconnect the power cord of any enhancement, grasp and pull the plug, not the cord.1. Connect the charger to a wall outlet.2. Connect the lead from the charger to the chargerconnector of your phone.To use the desk stand,connect the lead from the charger to the desk stand,and place the phone into the stand.If the battery is completely discharged, it may take a fewminutes before the charging indicator appears on thedisplay or before any calls can be made.The charging time depends on the charger used. Charging a BL-4C battery with the AC-5charger takes approximately 1 hour and 30 minutes while the phone is in the standby mode.