Call functionsMake a callNumber dialing1. Enter the phone number, including the area code.For international calls, press * twice for theinternational prefix (the + character replaces theinternational access code), enter the country code, thearea code without the leading 0, if necessary, and thephone number.2. To call the number, press the call key. To adjust thevolume in a call, press the volume key up or down.3. To end the call or to cancel the call attempt, press theend key.You can search for a name or phone number that you havesaved in Contacts. See "Search for a contact," p. 40. Pressthe call key to call the number.To access the list of dialed numbers, press the call key oncein the standby mode. To call the number, select a numberor name, and press the call key.Dialing shortcutsAssign a phone number to one of the number keys, 2 to 9.See "Dialing shortcuts," p. 41.Call the number in one of the following ways:Press a number key, then the call key.ORIf Speed dialling is set to On, press and hold a numberkey until the call begins.Further details are described in Speed dialling. See"Call," p. 48.Enhanced voice dialingYou can make a phone call by saying the name that issaved in the contact list of the device.Voice commands are language-dependent. Set theRecognition lang. before using voice dialing. See"Phone," p. 48.Note: Using voice tags may be difficult in a noisyenvironment or during an emergency, so you should notrely solely upon voice dialing in all circumstances.1. In the standby mode, press and hold the right selectionkey or the volume down key. A short tone sounds, andSpeak now is displayed.2. Speak the name of the contact you want to dial clearly.If the voice recognition is successful, a list withmatches is shown. The device plays the voicecommand of the first match on the list. If it is not thecorrect command, scroll to another entry.Using voice commands to carry out a selected devicefunction is similar to voice dialing. See "Voicecommands," p. 45. 25