SettingsClear device pairings1 To switch the headset off, press and hold for 5 seconds.2 Press and hold for 9 seconds. The headset beeps twice, and the red and greenindicator lights alternate.After the pairings are cleared, the headset enters pairing mode.Product and safety informationBattery and charger informationThis device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device asyou may damage the device.This device is intended for use when supplied with power from the following chargers: AC–11, AC-3, AC-8, AC-15, DC-4. Theexact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following:E, X, AR, U, A, C, K, B, or N.The battery can be charged and discharged hundreds of times, but it will eventually wear out.Talk and standby times are estimates only. Actual times are affected by, for example, device settings, features being used,battery condition, and temperature.If the battery has not been used for a long time, to begin charging, you may need to connect the charger, then disconnectand reconnect it.If the battery is completely discharged, it may take several minutes before the charging indicator is displayed.When your charger is not in use, unplug it from the electrical plug and the device. Do not leave a fully charged batteryconnected to a charger, as overcharging may shorten the battery’s lifetime. If left unused, a fully charged battery will loseits charge over time.Always keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetimeof the battery. A device with a hot or cold battery may not work temporarily.Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. Recycle whenpossible. Do not dispose as household waste.Use the charger for its intended purpose only. Improper use or use of unapproved chargers may present a risk of fire,explosion, or other hazard, and may invalidate any approval or warranty. If you believe the charger is damaged, take it to aservice centre for inspection before continuing to use it. Never use a damaged charger. Only use the charger indoors.Take care of your deviceHandle your device, charger and accessories with care. The following suggestions help you protect your warranty coverage.• Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrodeelectronic circuits. If your device gets wet, allow the device to dry.• Do not use or store the device in dusty or dirty areas. Moving parts and electronic components can be damaged.• Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can forminside the device and damage electronic circuits.9