45C a m e r aKeep a safe distance when using the flash. Do not use the flash on people or animals at closerange. Do not cover the flash while taking a picture.Self timer — to activate the self-timer (main camera only). Select theself-timer delay, and to activate the self-timer, select Activate.Sequence mode — to activate the sequence mode (images only). See ‘Captureimages in sequence,’ p. 46.Go to Gallery — to open the GalleryTo customise the toolbar, select Options > Customise toolbar. You can remove anitem from the toolbar, or change, add, or move items.The available options vary depending on the capture mode and view you are in.The setup settings return to the default settings when you close the camera.If you select a new scene, the colour and lighting settings are replaced by theselected scene. See ‘Scenes,’ p. 46. You can change the setup settings afterselecting a scene if needed.Location informationWith geotagging, you can add information about the geographic location wherethe image was captured to the file details of the photograph. You can use thisinformation in other applications. For example, in Nokia Maps you can see whatphotographs of different locations are available on a map.To activate geotagging in the camera, select Options > Settings > Recordlocation > On.When the location information is added to the image information, is shown atthe bottom of the display. If no positioning information is available fromsatellites, is displayed.If the location information is not available, GPS stays on in the background for afew minutes. If a satellite connection is found within that time, all the imagescaptured during that time are tagged based on the received GPS positioninginformation. See ‘Still image camera settings,’ p. 48.After capturing an imageAfter you capture an image, select the following from the active toolbar (availableonly if Show captured image is set to On in still image camera settings):• To send the image, press the call key, or select Send ( ).