Set up an internet accesspoint for packet data (GPRS)1. Select Menu > Tools > Settings >Connection > Access points.2. Select Options > New access point to create anew access point, or select an existing access pointfrom the list and then Options > Duplicate accesspoint to use the access point as a basis for the newone.3. Define the following settings.• Connection name — Enter a descriptive namefor the connection.• Data bearer — Select Packet data.• Access point name — Enter the name for theaccess point. The name is usually provided byyour service provider.• User name — Enter your user name if requiredby the service provider. User names are oftencase-sensitive and provided by your serviceprovider.• Prompt password — Select Yes to enter yourpassword each time you log into a server or Noto save the password in your device memory andautomate the login.• Password — Enter your password if required bythe service provider. The password is often case-sensitive and provided by the service provider.• Authentication — Select Secure to send yourpassword always encrypted, or Normal to sendyour password encrypted when possible.• Homepage — Enter the web address of the pageyou want to display as the home page when youuse this access point.4. After defining the settings, select Options >Advanced settings to define the advancedsettings or Back to save the settings and exit.Connect PC to webYou can use your device to connect your PC to the web.1. Connect the data cable to the USB connectors ofyour device and your PC.2. Select Connect PC to web. The necessary Windowssoftware is automatically installed from your deviceto the PC.3. Accept the installation in your PC. If asked, acceptalso the connection. When the connection to theweb is established, the web browser of your PCopens.You must have administrator rights to your PC, and theautorun option enabled in the PC. If not, run thesetup.exe file from the CD-ROM drive of your PC.46CyanCyan MagentaMagenta YellowYellow BlackBlackCyanCyan MagentaMagenta YellowYellow BlackBlack