Nokia IP40 Tele 8 to Check Point NG AINokia IP40 Security Platform User’s Guide v1.1 187Setting Up Nokia IP40 Tele 8To configure a VPN tunnel between Nokia IP40 Tele 8 and Check Point FP3, on IP40 Tele 8,(VPN client) add a VPN site.Setting Up Check Point NG AIConfigure a VPN-1 Edge/Embedded gateway object on the Check Point Smart Dashboard.To set up Check Point NG AI1. Create a gateway by using Check Point > VPN-1 Edge/Embedded gateway.2. Create a user and add the user to the VPN users group.3. Create a remote access VPN community. Include NG AI firewall object in the participating gateway. Include the Users group in the participating users.4. In the policy editor, create a rule with the following parameters:Source User: anyDestination: anyThrough: remote access communityTarget: NG AI firewall objectNoteYou can also use Check Point FP3 or FP4 in place of NG AI.Nokia Satellite X to Nokia Satellite X(VPN Gateway to Gateway)The VPN configuration between Nokia IP40 Satellite X and another Nokia IP40 Satellite Xenables you to establish site-to-site VPN connections between two Nokia IP40 site-to-site VPNgateways.NoteIn this configuration, both Nokia IP40 Satellite X site-to-site VPN gateways must have astatic IP address.Figure 8 on page 188 shows a sample implementation of the Satellite X to Satellite X solutionwith three Satellite X devices. Each Nokia IP40 device acts as a Site-to-Site VPN gateway for afully secure network. The networks communicate through VPN connections.
