5 About IP560 Appliance Network Interface Cards54 IP560 Security Platform Installation GuideFour-Port 10/100 Ethernet NICThe IP560 supports Nokia-approved, four-port UTP5 dual-mode (10-Mbps and 100-Mbps)Ethernet NICs installed in a PMC expansion slot. When you purchase a 10/100 Ethernet NICwith your IP560, the NIC is installed before the appliance is delivered to you. For informationabout how to add or replace a NIC, see Chapter 4, “Installing and Replacing Network InterfaceCards.”10/100 Ethernet NIC FeaturesThe four-port 10/100 Ethernet NIC supports PCI operation at 133 MHz and runs on Nokia IPSOv4.0.1 or higher.In the IP560, the four-port Ethernet NIC supports the following features: Tracing through tcpdump High bandwidth Full-duplex mode operation up to 100 Mbps Link speed auto advertising (10/100) PCI operation at 133 MHz Compliance with IEEE 802.3ab Gigabit Ethernet specificationsYou can configure and monitor Ethernet NIC interfaces by using Nokia Network Voyager.Specifically, you set the port speed and full-duplex or half-duplex mode with Network Voyager.For information about how to access Network Voyager and the related reference materials, see“Using Nokia Network Voyager” on page 42.Figure 12 Four-Port 10/100 Ethernet NIC Front Panel DetailsAfter the power is turned on and the cables are connected, the Ethernet link LEDs on both theIP560 and on the remote equipment illuminate to indicate the connection. As data is transmitted,the activity LEDs on the appliance illuminate.00641321123441000 BaseTLink LEDs (solid green)Activity LEDs (blinking green)Ports
