Nokia Mediamaster 9660S Owner's Manual
                              | |
Contents
| 
GB 11Once you have correctly connected the Mediamaster, you also have to perform some “BasicSettings”. During this procedure, helpful information is displayed at the bottom of the menus.Please note!The OK button always confirms a selection within these menus, and pressing it will take you to thenext step in the installation process. However, and this is important, often more than one value has tobe entered in a menu. First, perform all necessary settings on the different lines. Then, confirm themall simultaneously by pressing OK.You can always go back to the previous menu by pressing the BACK button.Use the buttons to move upwards and downwards from one line to another. Use to change settings.You can also use the numeric buttons on the remote control to select a line in a menu and to enternumeric values.This procedure is necessary only if your Mediamaster is connected to the TV with an RF cable.To tune your TV to the RF signal you might also need your TV manual in addition to this manual. Thesteps below explain what to do if you have been unable to use SCART cables in your connection.ü Plug in your Mediamaster.Tuning your TV to the Mediamaster.ü Select a channel number on the TV that is not currently used for other TV channels.ü Follow the instructions in your TV manual to tune the TV channel selector to UHF channel 43 (thisis the Mediamaster’s factory preset UHF channel). If you are already using this channel, selectanother non occupied UHF channel between 21to 69 on the TV.ü When you have correctly changed the UHF channel number you will see the “Welcome” menu onthe TV screen. If there is interference from other channels you will have to change the chosenUHF channel.ü Follow the instructions in your TV manual to store this UHF channel as the channel used by yourMediamaster. You will have to select this channel when you want to watch digital TV/Radiochannels.ü Once the welcome message is visible, press the OK button on the Mediamaster’s remote controlto start the installation procedure.If for some reason you have to change the RF channel later, you can do this by using “SystemSettings” menu further on in this manual. If you have a VCR connected it must be tuned to adifferent UHF channel (between 21 to 69) than the Mediamaster.You may now proceed to “The Welcome Menu.”BASIC SETTINGSTuning procedure when RF connections are used |
Related manuals for Nokia Mediamaster 9660S
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine