GB 17To start the Mediamaster from stand-by mode, press the “ ” button or one of the numbered buttonson the remote control. It is also possible to start by pressing the button on the front of theMediamaster. Put the Mediamaster into stand-by by pressing again the “ ” button again.In stand-by mode the display will show the correct time. During viewing the channel number will alsobe displayed.Change channel with the numbered buttons or with the up/down buttons on the remote control.You can also use the buttons up/down on the front panel of the Mediamaster.You can also select TV (Radio) channel in the TV (Radio) channel list. See the “List of TV Channel”and “List of Radio Channel” of page 16 and 17.Every time you change channel you will receive information for4-5 seconds about the current programme. This informationincludes: Channel number, name, programme title, and timefor present and following programmes. Press “i” whilewatching a channel. If your Service Provider transmitsprogramme information you will see: Correct time, a smallamount of information for the current and next programme, the name and number of the channel, andfinally the start and finish time for the programme.If you want to get more detailed information, press “i” once more while the information box (banner)is shown. You will get extended information (if transmitted) about the current or next programme.By pressing the GUIDE button you obtain access to theTV Guide which gives the titles of the current programmes onthe different channels. By pressing the LEFT or RIGHT buttonyou also can also obtain information about the next programme.The minimized viewing window also helps you to selectchannels and information. Use the Up/Down buttons to movethe cursor to different programme areas. You can obtainextended information for a programme by pressing the “i” button.Select ChannelProgram Information. The “i” ButtonTV GuideStart/Stop Watching TVThe Radio Button