Nokia Mediamaster 9828 Owner's Manual

Nokia Mediamaster 9828 Owner's Manual Manual pdf 12 page image

GB 12This procedure is necessary only if your Mediamaster is con-nected to the TV with an RF lead and no SCART leads areused.To tune your TV to the RF signal you might also need your TVmanual in addition to this manual. The steps below explain whatto do if you have been unable to use SCART leads in your con-nection.• Plug in your Mediamaster.Tuning your TV to the Mediamaster• Select a channel number on the TV that is not currently usedfor other TV channels.• Follow the instructions in your TV manual to tune the TV chan-nel selector to UHF channel 43 (this is the Mediamaster’s fac-tory preset UHF channel). If you are already using this chan-nel, select another non occupied UHF channel between 21to69 on the TV.• If you need to change UHF channel you do as follows:First you change on the Mediamaster. Use the or buttonson the front panel of the Mediamaster, or on the remote. Youwill see the UHF channel number displayed on the front panelof the Mediamaster. Then, tune the TV channel selector to thesame UHF channel.• When you have correctly changed the UHF channel numberyou will see the ”Welcome” menu on the TV screen.If there is interference from other channels you will have tochange the chosen UHF channel.• Follow the instructions in your TV manual to store this UHF chan-nel as the channel used by your Mediamaster. You will have toselect it when you want to watch terrestrial digital TV channels.• Once the welcome message is visible, press the OK buttonon the Mediamasters remote control to start the installationprocedure.If for some reason you have to change the RF channel later,you can do this by using TV settings menu further on in thismanual. If you have a VCR connected it must be tuned to a dif-ferent UHF channel (between 21 to 69) than the Mediamaster.You may now proceed to “First Time Installation.”Procedure when RF Connections are UsedINSTALLATION OF THE MEDIAMASTER• Plug in your Mediamaster• Now you will see the ”Welcome” menu on the screen.• Press OK on the Mediamaster remote control to start the In-stallation procedure.You may now proceed to “First Time Installation.”Switching on for the First Time withSCART Connections