[ 86 ]Note: Check with your service provider to make sure this service isavailable in your network.1 Make a call to the first participant as usual. When you are ready toplace a call to the next party:2 Press Options, then press New call.3 Enter the number and press the Send key (or press Search to recallthe number from the phone book).4 Press the Send key again to connect both parties.5 To end the call, press the End key. This action disconnects both parties.End callsTo end a conference call (disconnect with all callers), press the End key.Or you can also press Options, then select End all calls.Disconnect second partyWhile all three parties are connected, pressing the Send key disconnectsthe second caller, keeping the first party’s call active.Disconnect first partyIf you wish to disconnect with the first party and remain connected to thesecond party, have the first party terminate the call on his/her end.• SEND OWN CALLER ID WHEN CALLINGThis feature allows you to block caller ID when you call someone (yournumber will not be displayed on their caller ID). This feature may onlybe effective when calling a number equipped with caller ID.Note: This feature is available only when supported by the wirelessnetwork and may not function if you are roaming.Important: This feature works on a call-by-call basis. You mustenable this feature each time you want to block the sending ofyour own number to the recipient’s caller ID.
