Camera49• To return to the viewfinder to capture a new image,press the capture key.To use the picture as wallpaper in the active standby, selectOptions > Set as wallpaper.To set the image as a call image for a contact, select Setas contact call image.Still image camera settingsThere are two kinds of settings for the still image camera:Image setup and main settings. To adjust Image setup, see‘Setup settings—adjust color and lighting’, p. 50. The setupsettings return to the default settings after you close thecamera, but the main settings remain the same until youchange them again. To change the main settings, selectOptions > Settings and from the following:Image quality—Print 5M - Large (2592x1944 resolution),Print 3M - Medium (2048x1536 resolution), Print 2M -Medium (1600 x 1200), E-mail 0.8M - Med. (1024x768resolution), or MMS 0.3M - Small (640x480 resolution).The better the image quality, the more memory the imageconsumes. If you want to print the image, select Print 5M- Large, Print 3M - Medium, or Print 2M - Medium. Ifyou want to send it through e-mail, select E-mail 0.8M -Med.. To send the image through MMS, select MMS 0.3M- Small.These resolutions are only available in the main camera.Add to album—Select whether you want to save theimage to a certain album in the gallery. If you select Yes,a list of available albums opens.Show captured image—Select Yes if you want to see thecaptured image after it is taken, or No if you want tocontinue taking pictures immediately.Default image name—Define the default name for thecaptured images.Extended digital zoom (main camera only)—Select On toallow the zoom increments to be smooth and continuousbetween digital and extended digital zoom. If you want tolimit the zoom to where the selected image quality ismaintained, select Off.Capture tone—Select the tone you want to hear whenyou take a picture.Memory in use—Select where to store your images.Rotate image - Select whether you want the image to berotated the right way up when you open it in the gallery.Restore camera settings—Select Yes to return the defaultvalues to the camera settings.FlashThe flash is available only in the main camera.