![Nokia X6-00 User Manual Manual pdf 148 page image](https://manuals-archive2.s3.amazonaws.com/5396279/340ba543b9266439e9c2515b2bd00cc9148f.jpg)
Edit a packet data access pointSelect an access point group and access point marked with . Follow theinstructions from your service provider.Select from the following:Access point name — The access point name is provided by your service provider.User name — The user name may be needed to make a data connection, and isusually provided by your service provider.Prompt password — If you must enter the password every time you log in to aserver, or if you do not want to save your password in the device, select Yes.Password — A password may be needed to make a data connection, and is usuallyprovided by your service provider.Authentication — To always send your password encrypted, select Secure. Tosend your password encrypted when possible, select Normal.Homepage — Depending on the access point you are setting up, enter the webaddress or the address of the multimedia message centre.Use access point — Set the device to connect to the destination using this accesspoint after confirmation or automatically.Modify advanced packet data access point settingsSelect Options > Advanced settings.Select from the following:Network type — Select the internet protocol type to transfer data to and fromyour device. The other settings depend on the selected network type.Phone IP address (for IPv4 only) — Enter the IP address of your device.148 Connectivity© 2010 Nokia. All rights reserved.