2 Open the access point group that has the desired WLAN access point, and selectthe access point.You can also define 802.1x or WPA/WPA2 settings when creating a new WLANaccess point.3 Select WLAN security mode > WPA/WPA2 or 802.1x.4 Select WLAN security settings > WPA/WPA2 > EAP to use an extensibleauthentication protocol (EAP) plug-in, or Pre-shared key to use a password.The same password must be entered on the WLAN access point device.If you selected EAP, define the EAP plug-in settings according to the instructionsfrom your service provider.Connections in WPA2 only mode are applicable to WPA2 enabled devices only.The available options may vary.Advanced WLAN settings1 Select Menu > Settings and Connectivity > Destinations.2 Open the access point group that has the desired WLAN access point, and selectthe WLAN access point.You can also define advanced WLAN settings when creating a new WLAN accesspoint.3 Select Options > Advanced settings, and define the following:IPv4 settings — Enter the IP address of your device, the subnet IP address, thedefault gateway, and the IP addresses of the primary and secondary DNS servers.For these addresses, contact your internet service provider.IPv6 settings — Define the type of DNS address.Ad-hoc channel (only for Ad-hoc) — To enter a channel number (1-11) manually,select User defined.Proxy server address — Enter the address for the proxy server.Connectivity 151© 2010 Nokia. All rights reserved.
