To avoid selecting a single access point every time the device makes a networkconnection, you can create a group that contains various access points to connect tothat network and define the order in which the access points are used.For example, you can add wireless LAN (WLAN) and packet data access points to aninternet access point group, and use the group for browsing the web. If you give WLANthe highest priority, the device connects to the internet through WLAN, if available, andthrough a packet data connection if not.To create a new access point group, select Options > Manage > New destination.To add access points to an access point group, select the group and Options > Newaccess point. To copy an existing access point from another group, select the group,tap the relevant access point if it is not already highlighted, and select Options >Organize > Copy to other dest..To change the priority of an access point within the group, select Options >Organize > Change priority.Packet data access pointsSelect Menu > Settings and Connectivity > Destinations > Access point, andfollow the instructions on the screen.To edit a packet data access point, open one of the access point groups, and select anaccess point marked with .Follow the instructions from your service provider.Select from the following:● Access point name — You obtain the access point name from your service provider.● User name — The user name may be needed to make a data connection, and isusually provided by your service provider.● Prompt password — If you must enter the password every time you log in to aserver, or if you do not want to save your password in the device, select Yes.● Password — A password may be needed to make a data connection and is usuallyprovided by your service provider.● Authentication — Select Secure to always send your password encrypted orNormal to send your password encrypted when possible.● Homepage — Depending on the access point you are setting up, enter the webaddress or the address of the multimedia message center.● Use access point — Select After confirmation if you want the device to ask forconfirmation before the connection using this access point is created, orAutomatically if you want the device to connect to the destination using this accesspoint automatically.Select Options > Advanced settings and from the following:● Network type — Select the internet protocol type to transfer data to and from yourdevice. The other settings depend on the selected network type.● Phone IP address (for IPv4 only) — Enter the IP address of your device.© 2008 Nokia. All rights reserved. 73
