Norac UC4 Plus Installation Manual

Also see for UC4 Plus Rogator 64 Series: Installation manual Installation manual Installation manual Installation manual Installation manual

Contents

Norac UC4 Plus Installation Manual Manual pdf 18 page image

134.4.3 RAU Valve Connections1. Refer to Figure 16.2. Connect the RAU Valve Drive PCB (C12) to the NORAC harness (Item C11) using harnessC17. Connect all 3 Weatherpack connectors.3. Plug item C12 into C18, and securely fasten the module to the sprayer with cable-ties.Figure 16: RAU PCB Wiring4. Connect Item C18 to the RAU valve drivers and power connections:a. Insert the 6-conductor wire into the RAU valve driver enclosure (SHC box) byremoving a plug from an unused hole. Use a strain-relief grommet to protect the cableand make the entry weatherproof.b. Disconnect the wires for the left and right tilt valve coils from their respective terminalswithin the SHC box. These valves are no longer used after this install.c. Connect the wires to the RAU drivers (via the screw terminals) as listed below. Teethe wires in together with the exiting wiring for all boom function connections.RAU CONNECTION C18 WIRE+12V BLACK+12V BLUEDIRECTION 1 (BLUE DIR. WIRE) WHITEDIRECTION 2 (YLW/GRN DIR. WIRE) BROWNMAIN LIFT GREENSLANT RED