Norac UC4+ Installation Manual

Also see for UC4+: Installation manual Installation manual Manual Installation manual Operator's manual

Contents

Norac UC4+ Installation Manual Manual pdf 21 page image

184.6 HYDRAULIC I NSTALLATIONWARNING!The hydraulic system creates very highpressure. Before disconnecting any hydrauliclines ensure all pressure has been bled fromthe system. When changing the boomhydraulic hoses leave the booms inTRANSPORT POSITION.IMPORTANT:Component failure due to oil contamination isnot covered under the UC4+ Spray HeightControl system warranty. It is recommendedthat a qualified technician does the hydraulicinstallation.4.6.1 Valve Assembly1. On a clean surface remove all plastic plugsfrom the NORAC hydraulic Valve (V01)(Figure 20).Figure 20 – NORAC Valve Block2. Install the 6MB 6MJ (F07) fittings on the "P"and "T" ports and tighten to 18 ft-lbs.3. Install the 6MB 6MJ (F07) fittings on the“B” ports and tighten to 18 ft-lbs.4. Install the 6MBP fittings into the “A” portsand tighten to 18 ft-lbs.