62.4 Pull Type: Control Module on Sprayer1. Securely mount the control module (E01) on the sprayer near the CAN-bus connection.2. Tee the CAN-bus interface cable (C40) in to the John Deere CAN-bus. Connect the 6 pinDeutsch plug on cable C40 to the end of the control module with only one Deutschconnector.3. Connect the power cable (C30) to one of the two CAN-bus connectors on the control module.Connect the other end of the power cable to a 15A, +12 VDC source.4. Connect cable C01 to the other CAN-bus connector and route the cable towards the rear ofthe sprayer.Figure 4: GS2 2600 Display Kit – Pull Type Sprayer (Control Module on Sprayer)