Norco SHB-970 User Manual
                                                         | |
SHB-970 Industrial Full Size CPU Card5（2）Hold the CPU by both sides and Position the CPU over the socket, making sure that thegold triangle is on the bottom-left corner of the socket then fit the socket alignment key into theCPU notch.（3）Check if the CPU installation is ok and then close the CPU socket cover.Please follow the steps below to install CPU FAN:（1）Make sure the CPU FAN matches well with the CPU surface and then fix the FAN on the board.（2）Connect the FAN power cord to the board CPU FAN socket.2.2.2 Install DIMMBoard provides 2x DIMM slots, please keep following points in mind when installing memorybank:1. When installing memory bank, please align its notch with the alignment mark on the socketand then press the memory bank slowly into the socket.2. Please choose the memory banks that match our motherboard.2.3 Jumper Setting2.3.1 CMOS Clear/Hold Jumper Setting（JCC1, JCC2）CMOS is powered by onboard button cell. Clearing CMOS will lead to permanent eliminationof previous system settings and reset to the original system setting (the factory setting).Steps:（1）Shut off the computer and disconnect power supply（2）Make jumper cap JCC Pin 1-2 short for 5~6 sec and then back to Pin 2-3（3）Power on the computer and press ”Del” key to enter into BIOS setting whensystem starts, then reload optimal defaults（4）Save and Exit. |
Related manuals for Norco SHB-970
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine