Norcold 2117 Installation Manual

Also see for 2117: Owner's manual Parts list Owner's manual

Contents

Norcold 2117 Installation Manual Manual pdf 10 page image

Installation Manual 10If the design of the vehicle does not allow you to install a roof exhaust vent, install an upper side-wall exhaust vent:NOTE: The refrigerator is 23.75 in. min. to 24.05 in. max. from the rear of the breaker to the rearof the condenser [22] and is 61.35 in. min. to 61.65 in. max. from the bottom of therefrigerator to the bottom of the refrigerator condenser [23] (See Art01803).- Install the upper side-wall exhaust vent [24] so that the distance [25] from the bottom of theenclosure to the top of the rough opening for the upper exhaust vent is at least 71.0 inches(See Art01803 and Art01806).- Align the upper exhaust vent horizontally above the lower intake vent [9].Install an Upper Side-Wall Exhaust VentIf the enclosure depth is 26 inches or more (See Art01785):- Install an angled top baffle [172] between the top rear edge of the refrigerator and theinside edge of the upper exhaust vent opening.- Make sure that the angled top baffle is less than 1/4 inch from the top of therefrigerator.- Make sure that the angled top baffle is no more than 45° from vertical [20].- Install an inside corner baffle [173] between the outside edge of the upper exhaustvent opening and the solid box baffle.- Make sure that the inside corner baffle is approximately parallel to the angled topbaffle.- Install a wood or an aluminum or galvanized sheet solid box baffle [21] in the rear ofthe enclosure.- Make sure that the bottom of the solid box baffle is 18 inches to 18 1/2 inchesabove the bottom of the enclosure [17] (4 1/4 inches to 4 3/4 inches above the topof the lower intake vent opening) [18] .- Make sure that the back of the solid box baffle is perpendicular to the bottom of theenclosure.- Make sure that the back of the solid box baffle is either against the top of theenclosure or against the inside corner baffle [173] (depending on the vehicledesign).- Make sure that the solid box baffle is one inch or less from the coils [10] andcondenser [11] of the refrigerator.- Make sure that the solid box baffle is the full width of the inside of the enclo-sure.Art017851420172211811917101739Art018032223