Within 20 seconds the flame will go out, indicatingthe safety lock-out circuit is operational. Reconnectthe wire to the ignition module upon completion ofthe test.Door Panel InstallationThe Norcold refrigerator doors provide slots for in-serting decorative panels. Installation of the panels isaccomplished by removing the handle assembly, in-serting the decorative panel, and re-inserting thehandle assembly. This procedure applies to bothdoors. (See Figure 12)The frame slots are designed to accept panel thick-ness up to 3/16" maximum.TABLE 4PANEL DIMENSIONS662, 6636162, 6163682, 6836182, 6183UpperDoor19 11/16" x 16" 19 11/16" x 16"LowerDoor19 11/16" x 32 1/4"19 11/16" x 39 1/4"Note:use this dimensionfor models 652,3 &6052,3 outer doorINSTRUCTIONS1. Prepare panel by cutting to size indicated in ac-companying chart. (See TABLE 4)2. Remove handle assembly (A) by removing fourscrews (B). (See Figure 12)3. Slide panel into frame slots.4. Replace the handle assembly.Instructions for Reversing Door SwingYour refrigerator is equipped with convertible hingeswhich allows the door swing to be changed at any-time.TOOLS REQUIREDPhillips Screwdriver - Size #2Two Slotted ScrewdriversREMOVING THE DOORS1. Remove all items of food, juices, etc., from thedoors. Remove the juice rack and storage bins.Close both doors before removing hinge pins.2. Remove the top hinge pin using one of the slot-ted screwdrivers. Remove the center hinge pin(both pieces) using the two slotted screwdriv-ers; one on each end of the pin. Lastly, removethe bottom hinge pin. Be sure to save the pinsfor reassembly later. (See Figure 19)3. Remove the upper door by opening the doorslightly and pulling the bottom of the door awayfrom the refrigerator. Allow enough room toslide the door down off of the upper hinge pinshoulder. (See Figure 13)Ignition ModuleElectrode WireFigure 11Figure 12Figure 1311