Norcold N62X Installation Instructions Manual

Also see for N62X: Owner's instructions Service manual Service manual Owner's manual Owner's manual

Contents

Norcold N62X Installation Instructions Manual Manual pdf 6 page image

Installation Manual 6Put the refrigerator in position (See Art00962, Art00963, andArt00964):WARNING: Make sure the combustion seal [11] is notbroken, is completely around the refrigerator mountingflanges, and is between the mounting flanges and thewall of the enclosure If the seal is not complete, exhaustfumes can be present in the living area of the vehicle.The breathing of exhaust fumes can cause dizziness,nausea, or in extreme cases, death.- Push the refrigerator completely into the enclosure.- Put the upper trim piece [13] onto the front of the refrigerator.- Put screws [12] through the upper and lower mountingflanges on the front of the refrigerator and into the enclo-sure wall and floor.- Put a cap [14] on each of the screw holes in the upper trimpiece [13] on the front of the refrigerator.WARNING: Do not omit the bottom trim piece. Thispiece is part of the combustion seal.Install the RefrigeratorNOTE: The doors are made to accept decorative panels. Thedecorative panels must be 3/16 inch or less inthickness. Install the decorative door panels in therefrigerator doors before installing the refrigerator inthe vehicle.- Make an upper door panel that is 21 19/32 inches wide x 1417/32 inches high.- Make a lower door panel that is:- 21 19/32 inches wide and- 31 5/8 inches high (for N62X, N64X, and N64XIMmodels) or- 38 5/8 inches high (for N82X, N84X, and N84XIMmodels).- Pull the panel retainer [1] off each door (See Art00965).- Push the decorative door panel [2] into the slots of the door[3].- Push each panel retainer into the slot on the edge of thedoor.Install Decorative Door Panels (non-metaldoor models)- When using an upper side-wall exhaust vent:- If the depth of the enclosure is more than 24 inchesand less than 26 inches [18], install a bent aluminumor galvanized steel sheet baffle [19] to the rear of theenclosure (See Art01592).- Make sure that the bend of the baffle is the fullwidth of the inside of the enclosure.- Make sure that the bend of the baffle is flush withthe bottom edge of the upper intake vent doorframe.- Make sure that the top edge of the baffle is 1/4inch or less [20] below the condenser [3] and thatthere is 1/4 inch or less clearance [21] betweenthe lower rear corner of the condenser and thebaffle.- If the depth of the enclosure is more than 26 inches[22], install a wood or an aluminum or galvanized steelsheet solid box baffle [23] between the lower intakevent and the upper exhaust vent (See Art01593).- Make sure that the solid box baffle is the full widthof the inside of the enclosure.- Make sure that the bottom of the solid box baffle is18 inches to 18 1/2 inches above the bottom of theenclosure [26] (4 1/4 inches to 4 3/4 inches abovethe top of the lower intake vent opening REF) [27] .- Make sure that the back of the solid box baffle isperpendicular to the bottom of the enclosure.- Make sure that the horizontal top of the solid boxbaffle is even with the bottom edge of the upperexhaust vent [13].- Make sure that the vertical top edge of the baffle is1/4 inch or less [20] below the lower rear corner ofthe condenser [3].- Make sure that there is 1/4 inch or less clearance[21] between the rear of the condenser and thebaffle.